עט חריטה חשמלי 3 מהירות אלחוטי חרט עשה זאת בעצמך עם כבל טעינה

מאפיינים מוצהרים

Product Material:

Metal, Plastic

Adapt To Grinding Head Shank Diameter:

Approx.2.35mm / 0.09in

Chuck Depth:

Approx.25mm / 1in

Speed:

5000, 10000, 18000 Three Level

Power:

8W

Use Time:

The Third Gear Runs For More Than 1 Hour With No Load. If You Need To Use It For A Time, You Can Use It While Charging

Battery Voltage:

3.6V

Battery Type:

Lithium Battery (Shipped With Built in Battery)

Battery Capacity:

300mAh

Charging:

80% Full In 30 Minutes, Full In 60 Minutes

How to Use:

Install the grinding head:

1. Put the grinding head into the chuck:

2. Use an Hex wrench to tighten the grinding head fastening screws:

Start using:

1. Lightly press the power button once to enter the 1st gear working state, the speed is about 5000 rpm:

2. Press the power button once again to enter the second gear working state, the speed is about 10000 rpm:

3. Press the switch key once again to enter the 3rd gear working state, the speed is about 18000 rpm:

4. Tap the power button once again to enter the shutdown state:

5. During use, the load display will display the load status in real time according to the situation.:

6. Overload display, when the load is too large, the overload display light will be on for 2 seconds and the overload system will shut down for protection.:

7. According to the current situation of use, the user can grasp the load situation, please use it within the overload range.:

Package List:

1 x Host:

1 x Charging Cable:

1 x Drill Bit 1.0mm:

1 x Drill Bit 1.5mm:

1 x Slice 22mm:

1 x Slice 25mm:

1 x Slice 32mm:

1 x Slicing Connecting Rod:

1 x Metal Grinding Head:

30 x Grinding Needle:

1 x Grinding Needle Storage Box:

1 x User Manual:

Note:

1. Electric grinding power is small, non‑professional electric grinding, suitable for small engraving and grinding field.:

2. Do not place the electric grinder in a high :